Used Ericsson Baseband 6630 / 6631 baseband unit

Ericsson Mixed Mode Guide: Baseband 6630, 6648 and Radios

Ericsson “mixed mode” means running more than one radio standard (GSM, WCDMA, LTE, NR) at the same time on the same hardware. The short answer for buyers: Baseband 6630 is the unit to choose when a site still carries GSM or WCDMA alongside LTE, while Baseband 6648 is built for LTE, NR and LTE + NR mixed mode and does not cover 2G or 3G. On the radio side, Ericsson Radio System units such as Radio 2219, 4415 and 4428 are multi-standard, but which standards are supported depends on the band variant, software release and licenses. This guide explains how the pieces fit together and what to check before you buy used units.

What “mixed mode” means in Ericsson networks

Ericsson describes its Radio System radios as multi-standard: the same radio can operate in one standard at a time (single mode) or in several standards simultaneously (mixed mode). There are two sides to this:

  • Mixed mode baseband – one baseband unit processes traffic for two or more standards at once, instead of using a separate digital unit per standard.
  • Mixed mode radio – one radio unit transmits carriers of different standards on the same band, for example GSM and LTE together on a 1800 MHz radio.

Both are software features that must be enabled and licensed on the node. Buying the right hardware is the first step, but the operator’s software release and license set decide what actually goes live.

Mixed mode vs spectrum sharing

Mixed mode is not the same as spectrum sharing. In mixed mode, each standard uses its own block of spectrum within the radio’s bandwidth. Ericsson Spectrum Sharing (ESS) is a separate software feature that lets LTE and NR share the same frequency block dynamically. If your plan depends on ESS, confirm with your Ericsson software documentation that the band and radio combination supports it.

Baseband 6630: the multi-standard workhorse

The Ericsson Baseband 6630 is a 1U, 19-inch unit designed for mixed mode across 2G, 3G and 4G. Ericsson’s product material lists GSM, WCDMA and LTE in single mode, plus mixed mode combinations G+W, G+L, W+L and G+W+L, with Massive IoT support as well. Later software releases also added NR + LTE mixed mode on this unit.

Key hardware points relevant to mixed mode sites:

  • 15 CPRI ports for connecting radio units, so one baseband can serve several bands and sectors.
  • IDL ports for linking two basebands together when one unit is not enough.
  • Dual -48 V DC power feed.

This makes Baseband 6630 the common choice for operators who still run GSM or WCDMA layers and want to consolidate them onto one digital unit with LTE.

Baseband 6648: LTE and NR only

The Ericsson Baseband 6648 belongs to the RAN Compute family and was released in 2020 as a higher-capacity unit for 4G and 5G sites. Ericsson’s baseband description lists its main features as NR, LTE and NR + LTE mixed mode, together with Elastic RAN and backhaul cascading. Ericsson quotes up to 10–15 Gbps downlink and 3 Gbps uplink throughput.

The important point for mixed mode planning: GSM and WCDMA are not part of the Baseband 6648 feature set. If a site needs 2G or 3G, it either keeps a separate baseband for those standards or uses a multi-standard unit such as the 6630. Ericsson also positions Baseband 6631 as a multi-standard option covering 2G to 5G.

Which standards each unit supports

The table below summarizes the standards documented for common units. Radio support varies by band variant, so always check the specific product number (KRC) against Ericsson’s radio capabilities documentation.

UnitTypeStandards (as documented)Mixed mode notes
Baseband 6630Baseband, 1U 19″GSM, WCDMA, LTE, IoT; NR in later softwareG+W, G+L, W+L, G+W+L; NR + LTE
Baseband 6648Baseband, 1U 19″LTE, NR, IoTNR + LTE only
Radio 22192T2R, up to 2×80 WGSM, WCDMA, LTE, NR (band dependent)GSM up to 7 carriers in multi-standard operation; IBW up to 40 MHz (20 MHz for GSM)
Radio 44154T4R, up to 4×40 WWCDMA, LTE, NR; GSM on some bandsBand variant decides GSM support
Radio 44284T4RWCDMA, LTE, NR; GSM on some bandsBand variant decides GSM support

Radios: one unit, several standards

Ericsson’s radio capabilities document lists Radio 2219, 4415 and 4428 variants with support for WCDMA, LTE, Massive IoT, NR and ESS, with GSM listed for specific band variants. Regulatory test reports confirm this in practice: for example, a Radio 2219 B5 was tested in a combined WCDMA + GSM configuration, and Radio 4415 B3 is listed for GSM and LTE in its RF exposure report.

For 2T2R sites, the Radio 2219 B8 is a typical 900 MHz unit where operators keep GSM running while refarming part of the band to LTE. For 4T4R capacity layers, the Radio 4415 B3 is a common 1800 MHz choice. For background on which radios connect to which basebands, see our earlier guide on Ericsson radio and baseband compatibility.

Licenses and hardware activation codes

Ericsson controls several radio capabilities through Hardware Activation Codes (HWACs). According to the radio capabilities documentation, output power above a certain level, WCDMA carriers and GSM carriers require HWACs, and LTE/NR carrier bandwidths are also tied to licenses. A used radio can be physically capable of mixed mode while the receiving network still needs the right licenses installed on its own node.

What to check before buying used units for a mixed mode site

  1. Standards on site today and planned. If GSM or WCDMA stays live, plan around Baseband 6630 (or 6631). If the site is LTE + NR only, Baseband 6648 is the higher-capacity option.
  2. Exact radio product number. Read the KRC number on the label. The band variant, not just the model name, determines which standards the radio supports.
  3. Software release. Mixed mode combinations, NR support on older basebands and ESS all depend on the software release running in your network.
  4. Licenses. Confirm your license set covers mixed mode baseband, mixed mode radio and the carrier count and power you need.
  5. CPRI capacity and optics. Count CPRI ports needed for all bands and sectors, and make sure the SFP modules match the radio and baseband interface rates.

FAQ

Can Baseband 6648 run GSM or WCDMA?

No. Ericsson documents Baseband 6648 for LTE, NR and NR + LTE mixed mode. For GSM or WCDMA, use a multi-standard unit such as Baseband 6630 or 6631, or keep a separate baseband for those standards.

Does Baseband 6630 support 5G NR?

Ericsson training material lists NR + LTE mixed mode for Baseband 6630, enabled through later software releases. Capacity for NR is lower than on Baseband 6648, which was designed for high-capacity 5G sites.

Can one Radio 2219 carry GSM and LTE at the same time?

Yes, on band variants that support GSM, with mixed mode radio enabled. The datasheet lists up to 7 GSM carriers in multi-standard operation and an instantaneous bandwidth of up to 40 MHz, limited to 20 MHz for GSM.

Is mixed mode the same as dynamic spectrum sharing?

No. Mixed mode gives each standard its own spectrum block. Ericsson Spectrum Sharing lets LTE and NR use the same block dynamically and is a separate software feature.

Buy tested Ericsson baseband and radio units

We supply used Ericsson Baseband 6630, 6631, 6648 and Radio 2219, 4415, 4428 and 4429 units for mixed mode sites; browse the full range in our Ericsson category. Every unit is functionally tested before shipment, and radio units are also VSWR tested. All units come with a 90-day warranty, and we ship worldwide in secure packaging. Contact us on WhatsApp at +86 187 3329 4669 or +86 139 3088 8705, email jack@telecombts.com, or use the form at https://telecombts.com/contact-us/.

We also buy surplus Huawei, Ericsson and Nokia equipment – send us your list here.

Shopping Cart