Can you run Nokia Flexi RF modules on AirScale baseband, or AirScale radios on a Flexi FSMF? In most cases, yes. AirScale capacity cards such as the ABIA accept both OBSAI (6 Gbps) and CPRI (9.8 Gbps) fronthaul, so legacy Flexi RF modules like the FRGU and FXED can connect to them. AirScale RF modules such as the ARGA and AREA list both FSMF and AirScale as supported system modules. AirScale common units (ASIA, ASIB) can also be chained with a Flexi Multiradio 10 System Module. The real limits come from the software release, optical link type and how the site is configured, not from the hardware generation alone. This guide covers each combination and what to check before you buy used units for a mixed site.
Why Flexi and AirScale Compatibility Matters
Many operators still run Flexi Multiradio 10 sites built around the FSMF system module with FBBA or FBBC capacity extension modules and Flexi RF modules. When they expand capacity, replace failed units or add a band, they rarely swap the whole site in one step. Nokia designed AirScale to fit into this: its own AirScale base station material states that the platform is compatible with Flexi Multiradio 10 base stations and that AirScale-Flexi configurations allow Flexi sites to be expanded with AirScale units.
For buyers of used equipment, this means you can source the exact unit you need, whether that is an AirScale radio for an FSMF site or a capacity card to drive existing Flexi RF modules, without rebuilding the whole site. The details still matter, though, because a wrong assumption about fronthaul or software support can leave a unit sitting unused.
The Two Fronthaul Worlds: OBSAI and CPRI
The key to compatibility is the optical interface between baseband and radio:
- Flexi RF modules (FRGU, FXED, FRMF, FRHF) use OBSAI RP3 links at 6 Gbps, with three optical interfaces per module.
- FSMF with FBBA/FBBC uses OBSAI RP3 or CPRI at 6 Gbps. Nokia lists one optical port on FBBA and four on FBBC, for up to 12 optical ports with two FBBC modules.
- AirScale RF modules such as the ARGA and AREA use CPRI at 9.8 Gbps, with three optical interfaces.
- AirScale ABIA capacity cards have six SFP+ optical ports and support either OBSAI at 6 Gbps or CPRI at 9.8 Gbps.
Because the ABIA supports both protocols, it can serve as the bridge between older Flexi radios and the newer AirScale baseband.
Compatibility Matrix
The table below summarises published Nokia hardware information for the units most often found on mixed sites. Always confirm against the software release running on the target site.
| Unit | Type | Band | Fronthaul | Works with | Software listed by Nokia |
|---|---|---|---|---|---|
| FRGU | Flexi RF module, 6 x 60 W | 2100 MHz (B1) | 3 x 6 Gb OBSAI | FSMF; AirScale via OBSAI-capable capacity card | FDD-LTE 16, WCDMA 16, SRAN 16.2 |
| FXED | Flexi RF module, 6 x 60 W | 1800 MHz (B3) | 3 x 6 Gb OBSAI | FSMF; AirScale via OBSAI-capable capacity card | FDD-LTE 15, GSM 16, SRAN 16.2 |
| FRMF | Flexi RF module, 6 x 60 W | 800 MHz (B20) | 3 x 6 Gb OBSAI | FSMF; AirScale via OBSAI-capable capacity card | FDD-LTE 16, SRAN 16.2 |
| FRHF | Flexi RF module, 6 x 40 W | 2600 MHz (B7) | 3 x 6 Gb OBSAI | FSMF; AirScale via OBSAI-capable capacity card | LTE RL50, SRAN 16.2 |
| ARGA | AirScale RF module, 6T6R, 480 W | 2100 MHz (B1) | 3 x 9.8 Gb CPRI | FSMF and AirScale (listed by Nokia) | LTE 19, SRAN 19 |
| AREA | AirScale RF module, 6T6R, 480 W | 1800 MHz (B3) | 3 x 9.8 Gb CPRI | FSMF and AirScale (listed by Nokia) | FDD-LTE 18A, SRAN 18A |
Combination 1: Flexi RF Modules on AirScale Baseband
This is the common case when an operator moves baseband to AirScale but keeps working radios in the field. An AirScale system module is built from a subrack (AMIA indoor, or AMOB/AMOC/AMOD outdoor), a common unit (ASIA or ASIB) and one or more capacity cards. The Nokia ABIA supports OBSAI at 6 Gbps on its optical ports, which matches the interface of Flexi RF modules such as the Nokia FRGU.
Points to check:
- The capacity card variant. Newer cards such as the ABIC add FD-CPRI and eCPRI; check that the card you plan to use supports OBSAI if you are connecting Flexi radios.
- The software release on the AirScale system module and whether it supports the specific Flexi RF module and the technology you need (GSM, WCDMA or LTE).
- SFP modules. Optical transceivers must match the link rate and distance; mixing 6 Gbps and 9.8 Gbps links on one card needs correct port configuration.
Combination 2: AirScale RF Modules on Flexi FSMF
When an FSMF site needs a replacement or additional radio and Flexi RF stock is limited, AirScale radios can be an option. Nokia lists FSMF as a supported system module for both the Nokia ARGA (Band 1) and the AREA (Band 3). The FSMF and its FBBA/FBBC extensions run optical links at 6 Gbps, while the ARGA and AREA are specified with 9.8 Gbps CPRI interfaces, so confirm with the site’s software release and configuration which link rate and features are available in this combination.
The software release is critical here. Nokia lists the AREA from FDD-LTE 18A / SRAN 18A and the ARGA from LTE 19 / SRAN 19. An FSMF running an older release will not support these radios until it is upgraded. For the Nokia Flexi BBU FSMF, check which release it is running before ordering AirScale radios for it.
Combination 3: Chaining AirScale and Flexi System Modules
Nokia describes both the ASIA and ASIB common units as compatible for chaining with the Flexi Multiradio 10 System Module. This allows an operator to add AirScale baseband capacity next to an existing FSMF rather than replacing it. In practice, this suits sites where the FSMF still carries a working configuration, for example GSM or WCDMA, while new LTE or 5G capacity is added on AirScale. Note that the 5G-focused common units (ASIK, ASIL) are not described with the same Flexi chaining compatibility.
If you are planning a full migration rather than a mixed site, see our earlier guide on the Nokia FSMF to AirScale upgrade path.
Checklist Before Buying Used Units for a Mixed Site
- Confirm the product code. Record the full Nokia product code and variant from the label, not only the short name. AirScale and Flexi units have several variants.
- Match the band. FRGU and ARGA are Band 1, FXED and AREA are Band 3, FRMF is Band 20 and FRHF is Band 7. Check against your licensed spectrum and antenna system.
- Check the software release on the system module that will drive the radio, and the minimum release Nokia lists for the radio.
- Check fronthaul type. OBSAI radios need an OBSAI-capable port; CPRI radios need a CPRI-capable port at the right rate.
- Plan optics and cabling. Order SFPs and fibre that match the link rate and distance.
- Check power and installation. 6-pipe RF modules such as the ARGA and AREA have different power and mounting needs from older radios. Confirm the site’s DC power and installation space.
FAQ
Can a Nokia FRGU connect to an AirScale ABIA?
The FRGU uses 6 Gbps OBSAI links, and the ABIA supports OBSAI at 6 Gbps on its optical ports, so the interfaces match. Confirm that the software release on the AirScale system module supports the FRGU for your technology.
Does the Nokia ARGA work with FSMF?
Nokia lists FSMF and AirScale as supported system modules for the ARGA. The ARGA is listed from LTE 19 / SRAN 19, so the FSMF must run a compatible release.
Can I keep my FSMF and add AirScale capacity?
Yes. Nokia describes the ASIA and ASIB common units as compatible for chaining with the Flexi Multiradio 10 System Module, which allows AirScale capacity to be added alongside an existing FSMF.
Is the AREA the AirScale equivalent of the FXED?
Both cover 1800 MHz (Band 3) with six pipes. The AREA is an AirScale 6T6R module rated at 480 W with CPRI 9.8 Gbps links, while the FXED is a Flexi 6 x 60 W module with OBSAI 6 Gbps links. They are not drop-in identical; check the system module, software and site configuration.
Source Tested Nokia Flexi and AirScale Units
We supply used and refurbished Nokia Flexi and AirScale equipment, including system modules, capacity cards and RF modules. Browse the full range on our Nokia product page. Every unit is functionally tested before shipment, and radio units such as RF modules are also VSWR tested. All units come with a 90-day warranty, and we ship worldwide in secure packaging. To check compatibility for your site or request availability, contact us on WhatsApp at +86 187 3329 4669 or +86 139 3088 8705, email jack@telecombts.com, or use the form at https://telecombts.com/contact-us/.
We also buy surplus Huawei, Ericsson and Nokia equipment. Send us your equipment list.
